Look Kéo Blade Carbon TI Pedals Black

Look Kéo Blade Carbon TI pedals with a new design that integrates the blade completely for unmatched aerodynamics. Equipped with a body and a carbon blade, the TI Carbon Blade incorporates a Titanium shaft for a weight of only 95 g per pedal. The shaft line of the new Blade Carbon has been completely redesigned. It is built around an oversized shaft and a through shaft line consisting of a ball bearing in the internal position and a needle housing installed in a central position under the - support surface. This new construction allows to gain around 2 watts at 100 revolutions per minute. The distance between the ball bearing and the needle bushing has been increased by 25%. This allows to provide greater rigidity to the assembly of the axis line and, consequently, to improve the transmission of the power. Sealing has also been the subject of special attention. This has been improved by 120% for superior reliability and durability. To do this, the new shaft line integrates a new cap equipped with an O-ring at its outer end. In the internal position, it is equipped with a double lip seal.

Look axes are validated only after passing a rotation test of 2 million cycles at 100 rpm with a load of 90 kg on the center of the pedal and an eccentric rotation (which creates an impact on each turn). This test is far superior to the current standard: EN14781.

To respond to the wishes of the most demanding cyclists, especially competitors, the pedal-cleat system must allow effective power transfer thanks to a larger and more rigid contact surface. The - Blade Carbon support surface is equipped with an overmolded stainless steel sheet 67 mm wide. This optimizes the cleat / pedal contact zones, regardless of the pedaling angle adopted. With 700 mm2 of - Support surface, the Blade Carbon offers an optimized contact platform for unmatched efficiency and power transfer in the market. Its weight / power ratio positions it very widely above its competitors. The use of carbon for the body and the blade allows to lighten the weight of the pedal and also gain stiffness for a better power transfer. The Blade technology is a technical innovation highlighted in the history of the automatic pedals, since it provides numerous advantages: lightness, aerodynamics, a very safe draft / rejection.

Characteristics:
- Use: Road
- Body: Carbon
- Axis: Titanium
- Threaded: 9/16 X 20 mm
- Bearings: 1 ball bearing, 1 needle bearing
- Height axis / sole: 14.8 mm
- Foot pedal / connecting rod distance: 53 mm
- Support width: 67 mm
- Support surface: 700 mm2
- Tension: Pedals delivered with carbon leaves of 16 installed + additional carbon sheets 12 (carbon sheets 20 available separately)
- Coves: gray Kéo Cleat coves
- Angular freedom: 0º, 4,5º or 9º according to the type of cala (black, gray, red)
- Weight: 95 g (248 g pair with cleats and screws)
- Accessories: 2 pairs of sheets + 1 pair of Kéo Cleat gray coves + hardware